Expansion tank design

Moderators: scimjim, Roger Pennington, Lukeyboy46, philhoward, erikscimitardemon

User avatar
Roger Pennington
RSSOC Member
Posts: 18738
Joined: Tue Aug 29, 2006 9:43 pm
Has thanked: 87 times
Been thanked: 395 times

Expansion tank design

Post by Roger Pennington » Tue Sep 12, 2017 4:39 pm

Ollieoldbeard wrote:
Tue Sep 12, 2017 4:22 pm
I always thought the pipe going into the expansion tank Iain a syphon type set up so it fills the tank and sucks it back up when it cools and as long as it doesn't run dry the syphon won't be broken, which allows built up crap to fall to the bottom and not be sucked up, so it the pipe was at the bottom it would. That make sense ?
That is the way it works on the Se6/6a. However the pipe end should be near the bottom (as it can't suck back water below it). To stop the pipe pressing on the bottom of the tank and getting blocked, it's important that the end of the pipe should be cut on a slant, that way the pointed end will touch bottom first, and holds the opening a short way up :)


....Roger

RSSOC member (since 1982)
- - - - - - - - - - - - - - - - -
Image

"Condition can be bought at any time; Originality, once lost, is gone forever" - Doug Nye

Ollieoldbeard
Posts: 204
Joined: Fri Oct 03, 2014 8:23 am
Location: BRISTOL
Has thanked: 2 times
Been thanked: 1 time

Expansion tank design

Post by Ollieoldbeard » Sun Sep 24, 2017 9:13 am

That makes perfect sense



Post Reply

Return to “Se6/6a/6b/GTC”