PJH 4L Project starts here

If you have a long-term project and would like to share/document progress, this is for you.

Moderators: scimjim, philhoward, Lukeyboy46, erikscimitardemon, Roger Pennington

Detour
Posts: 36
Joined: Tue Dec 29, 2015 2:04 pm
Has thanked: 6 times
Been thanked: 1 time

Re: PJH 4L Project starts here

Post by Detour » Sat Mar 05, 2016 10:43 am

Thanks TM I will put this to use when my frame gets back and don't worry my hand writing is just as bad at least using this and what I have left I should be able to get it sorted thanks again.



Detour
Posts: 36
Joined: Tue Dec 29, 2015 2:04 pm
Has thanked: 6 times
Been thanked: 1 time

Re: PJH 4L Project starts here

Post by Detour » Thu Mar 24, 2016 10:28 pm

Ok so been awhile since my last update!

I got my chassis back from the grit blasters and its not in a cardboard box so i'm happy they found a few more holes for me to weld up but nothing terrible. I also had the better parts of the chassis etch primed at the same time.
scimitar 22 small.jpg
scimitar 22 small.jpg (167.53 KiB) Viewed 1066 times
scimitar 23 small.jpg
scimitar 23 small.jpg (135.66 KiB) Viewed 1066 times
I started to cut out the bad bits.
scimitar 24 small.jpg
scimitar 24 small.jpg (169.75 KiB) Viewed 1066 times



Detour
Posts: 36
Joined: Tue Dec 29, 2015 2:04 pm
Has thanked: 6 times
Been thanked: 1 time

Re: PJH 4L Project starts here

Post by Detour » Thu Mar 24, 2016 10:33 pm

Then started to make the cardboard templates for the new panels.
scimitar 26 small.jpg
scimitar 26 small.jpg (147.61 KiB) Viewed 1062 times
scimitar 28 small.jpg
scimitar 28 small.jpg (151.96 KiB) Viewed 1062 times
Sheet steel is ordered and when I have all the panels made in card the fun job of remaking it all in steel starts.



Tinker man
RSSOC Member
Posts: 358
Joined: Thu Feb 04, 2016 7:39 am
Location: Davenham Cheshire
Has thanked: 14 times
Been thanked: 16 times

Re: PJH 4L Project starts here

Post by Tinker man » Fri Mar 25, 2016 10:21 am

Good stuff. Doesn't look as bad as first feared then? Keep going and good luck, Ian


If it is made of nuts and bolts I WILL take it apart..... going back together is a whole different ball game

Detour
Posts: 36
Joined: Tue Dec 29, 2015 2:04 pm
Has thanked: 6 times
Been thanked: 1 time

Re: PJH 4L Project starts here

Post by Detour » Sun Feb 19, 2017 10:07 pm

Hi all after a long break through work getting very busy and other stuff im back and excited to start on my project again but im sad to say PJH 4L is on hold for now and will most likely end up as my trackday fun car as the shear price of parts to put it back to something looking like a road going scimitar is just nuts! So im going to use another scimitar i purchased to complete my RX8 conversion then PJH 4L will become my road going track car watch this space.



Post Reply

Return to “Project Progress”