Discuss and exchange views and technical information about our cars.
4 posts • Page 1 of 1
- peter freeman
- RSSOC Member
- Posts: 10575
- Joined: Thu Aug 31, 2006 12:12 pm
- Location: Newcastle
- Has thanked: 9 times
- Been thanked: 438 times
Club traders or do as I did and replace with angle iron - the original U section IMO is just a water trap that leads to rust
- Posts: 139
- Joined: Fri Jan 20, 2017 12:19 pm
- Location: essex
- Has thanked: 2 times
- Been thanked: 5 times
are you looking for the chassis sill parts or the body sill inserts, if it's the latter I had some stainless ones made up by a local co for about £25, it's a horribly messy job though.
Cheers for the replies. Its the rotted out steel sections in the body. Chopped them out over xmas. I need to make up the rollover hoop bottoms too so will fab them up at work when it quietens down...Thanks.