SE5 Overriders

Discuss and exchange views and technical information about our cars.

Moderators: scimjim, philhoward, erikscimitardemon, Roger Pennington, Lukeyboy46

Post Reply
Adam H
RSSOC Member
Posts: 4
Joined: Wed May 29, 2013 12:00 am

SE5 Overriders

Post by Adam H » Wed Jul 18, 2018 7:54 pm

Refitting the front nose support bracket into my SE5 and supporting metalwork but looking at it, it seems to make a lot of sense to fit the overriders first. Is that correct?

Has anyone got a picture of the overrider bolts and how they attach to the car?

And I need two overriders, existing ones are bent. (I've read on here they are the same as Escort Mk1). Are there any stockists or is it a case of searching ebay?

Thanks

Adam



ard126k
Posts: 588
Joined: Tue May 24, 2011 4:24 pm
Location: Fife
Has thanked: 3 times
Been thanked: 17 times

SE5 Overriders

Post by ard126k » Thu Jul 19, 2018 6:45 pm

IMG_0911.JPG
IMG_0911.JPG (134.96 KiB) Viewed 162 times
Not the easiest place to photograph! This is looking up from the bottom of the overrider, the two long rivets are holding the rubber on the front. The brown thing is the strap which goes into the nose. You can just see the head of a bumper bolt which sits in a slot in the overrider and fastens to the strap. Finally the strap goes through a hole in the body and bolts onto the nose structure.
So all the interior metalwork needs to be in place first, then assemble the strap to the overrider and slide it through the hole in the body and bolt up. Easiest done with no grille in the air vent


1971 SE5 1977 SE6 1982 GTC

Post Reply

Return to “General Technical Discussion”